Techreo Reach Extender
-
$4,495 USD (excl taxes and delivery)
Extend the reach of your cobot / robot 610mm (24″)
- Lightweight design – 2.6 kg (5.7 lbs) – for example, this consumes only 16% of a FANUC CRX20 J5 moment
- Simplified ISO flange mounting (ISO50)
- Plug-n-play utilities – use common jumpers to connect to your end effector
- Protected Utilities – run thru the center of the tool
- Based on Techreo’s Gold Series tubes = Low deflection and rapid vibration damping
Benefits:
- If your cobot needs reach but can handle additional J5 moment load, Techreo’s Reach Extender is an elegant solution.
- You can reach farther, with a smaller, less expensive cobot.
- Your end tooling remains accurate and cycle times remain efficient
Industrial Robots Can Benefit as Well:
- Any application where accurate, additional reach is beneficial
How to Order:
- Please utilize our Contact page to specify your needs in terms of your robot / cobot’s wrist bolt pattern.
- We will respond immediately with a timing and delivered cost quote.
- Credit Card orders and PO’s are welcome.
Steps:
- Connect the reach extender to your cobot
- ISO50 bolt pattern is typical but an adapter flange enables nearly any wrist pattern to work
- Use jumpers to connect utilities
- Air
- Electrical (8-pin)
- LAN for vision systems
- Connect your tooling to the ISO50 pattern at the end of the Reach Extender
- Connect your utilities from the tooling to the Reach Extender wrist mount
Sample Photos/Video on CRX5 Demonstration
